Top rated products
-
Triggertech Primary Trigger
$164.99
-
TriggerTech Diamond Flat Straight
$304.99
-
TriggerTech Diamond Curved
$304.99
-
BT46-LW17 PSR Atlas Bipod
$354.95
-
BT47-LW17 PSR Atlas Bipod
$374.95
300 SAUM Brass
$89.55 – $104.48
Estimated arrival 1/24/24
300 SAUM Brass
300 SAUM BRASS (Short Action Ultramag) – ADG manufactured brass is optimized not only for consistency in performance, but also for durability. One of the ways we accomplished this is by optimizing the material in specific areas to strengthen it. With the optimized material geometry, our brass will generally have a different case volume than most other manufacturer’s brass and therefore will require a different charge weight to achieve the same pressures and velocities. We recommend using a reputable load data source and working up from their recommended minimum starting loads. Designed to work with chambers cut with the .296 neck reamer. No neck turning required!
We recommend reducing any existing charge weights by 10% and re-developing your specific load when replacing any component in a load recipe with a new component (brass, projectile, primer, or powder type). Failure to reduce charge weights established using other manufacturers brass may result in higher pressures and velocities while using ADG brass and may result in unsafe pressure levels.
| Caliber | 300 SAUM |
|---|---|
| Finish | Bright, Standard |
| Quantity | Retail Box (50 pc) |
| Case Weight | 216.9 grains (average) |
| Case Volume | 74.5 grains/H2O (average) |
| Neck Dimensions | Average Wall Thickness: 0.0151″ Average Loaded Neck OD: 0.3386″ |
| Finish: | Standard Anneal Line Visible, Bright & Shiny |
|---|
Related products
-
300 Norma Mag
$127.50Read more50 count box
Standard Annealed Finish
ADG 300 Norma Magnum
ADG manufactured brass is optimized not only for consistency in performance, but also for durability. One of the ways we accomplished this is by optimizing the material in specific areas to strengthen it. With the optimized material geometry, our brass will generally have a different case volume than most other manufacturer’s brass and therefore will require a different charge weight to achieve the same pressures and velocities. We recommend using a reputable load data source and working up from their recommended minimum starting loads.
We recommend reducing any existing charge weights by 10% and re-developing your specific load when replacing any component in a load recipe with a new component (brass, projectile, primer, or powder type). Failure to reduce charge weights established using other manufacturers brass may result in higher pressures and velocities while using ADG brass and may result in unsafe pressure levels.
