Top rated products
-
Triggertech Primary Trigger
$174.99
-
TriggerTech Diamond Flat Straight
$334.99
-
TriggerTech Diamond Curved
$334.99
-
BT46-LW17 PSR Atlas Bipod
$354.95
-
BT47-LW17 PSR Atlas Bipod
$374.95
Triggertech Trigger
$109.99
- Right hand
- Adjustable from 2.5-5.0 pound pull weight
- Right Hand
- Intended for SIDE BOLT RELEASE actions.
- These are a factory take off trigger from new rifles. Removal and installation marks present!
Triggertech Trigger
Right hand
Adjustable from 2.5-5.0 pound pull weight
Right Hand
Intended for SIDE BOLT RELEASE actions.
These are a factory take off trigger from new rifles.
TriggerTech Triggers Primary Special Diamond TriggerTech Triggers
| Configuration | PVD Coated, Stainless |
|---|
Related products
-
Sale!
7 PRC 2 Die Set
Original price was: $173.00.$119.99Current price is: $119.99.Read moreProduct Description
Full Length Die Set for Bottleneck Cases – Full length die sets for bottleneck cases contain two dies. The full length (FL) resizing die contains a decapping rod assembly with a neck expander (size button). The seating die (ST) includes bullet guide, built-in crimp ring and the proper seating plug.
ÂFull Length 2 Die Set Includes:• Full Length Resizing Die• Seating Die -
Sale!
Hornady Brass
Price range: $34.99 through $54.99Select options This product has multiple variants. The options may be chosen on the product pageHornady Brass Features: Hornady brass has tight Wall Concentricity – Concentricity helps to ensure proper bullet seating in both the case and the chamber of your firearm. Higher concentricity also aids in a uniform release of the bullet on firing, for optimal velocity and accuracy. Uniform Case Wall Thickness – Benchrest shooters have long known …
-
Sale!
300 PRC
Original price was: $97.85.$89.99Current price is: $89.99.Add to cart50 count box
Standard Annealed Finish
ADG 300 PRC
ADG manufactured brass is optimized not only for consistency in performance, but also for durability. One of the ways we accomplished this is by optimizing the material in specific areas to strengthen it. With the optimized material geometry, our brass will generally have a different case volume than most other manufacturer’s brass and therefore will require a different charge weight to achieve the same pressures and velocities. We recommend using a reputable load data source and working up from their recommended minimum starting loads.
We recommend reducing any existing charge weights by 10% and re-developing your specific load when replacing any component in a load recipe with a new component (brass, projectile, primer, or powder type). Failure to reduce charge weights established using other manufacturers brass may result in higher pressures and velocities while using ADG brass and may result in unsafe pressure levels.
