Top rated products
-
Triggertech Primary Trigger
$174.99
-
TriggerTech Diamond Flat Straight
$334.99
-
TriggerTech Diamond Curved
$334.99
-
BT46-LW17 PSR Atlas Bipod
$354.95
-
BT47-LW17 PSR Atlas Bipod
$374.95
Viridian Eon 3-9×40 Scope
Price range: $39.99 through $74.99
Original box is NOT included!
Viridian Eon 3-9×40 Scope
Duplex and BDC reticle available.
1 inch medium height rings included.
Manual included – no original box!
| Reticle | Duplex, BDC |
|---|
Related products
-
Sale!
Tikka Hawkins Featherweight Rings
Original price was: $100.00.$89.99Current price is: $89.99.Select options This product has multiple variants. The options may be chosen on the product pageTikka Hawkins Featherweight Rings Tikka Hawkins Featherweight Rings are a direct attach solution for your ultralight hunting rifle set-up. Machined out of a single piece of billet aluminum, these rings weigh in between 2-3 ounces and are rated for up to magnum caliber firearms. Featherweights are available in 1″ and 30mm diameters in Low / …
-
338 EDGE
Price range: $132.50 through $139.13Select options This product has multiple variants. The options may be chosen on the product page338 EDGE Additional information CALIBER 338 EDGE FINISH Standard / BRIGHT QUANTITY Retail Box (50 pc) CASE WEIGHT 264.7 grains (average) CASE VOLUME 114.6 grains/H2O (average) NECK WALL THICKNESS .0146″ (average) Our brass is tracked with a custom lot number for quality control which is located on the underside of box. Premium Rifle Cartridge Cases …
-
Sale!
300 PRC
Original price was: $97.85.$89.99Current price is: $89.99.Read more50 count box
Standard Annealed Finish
ADG 300 PRC
ADG manufactured brass is optimized not only for consistency in performance, but also for durability. One of the ways we accomplished this is by optimizing the material in specific areas to strengthen it. With the optimized material geometry, our brass will generally have a different case volume than most other manufacturer’s brass and therefore will require a different charge weight to achieve the same pressures and velocities. We recommend using a reputable load data source and working up from their recommended minimum starting loads.
We recommend reducing any existing charge weights by 10% and re-developing your specific load when replacing any component in a load recipe with a new component (brass, projectile, primer, or powder type). Failure to reduce charge weights established using other manufacturers brass may result in higher pressures and velocities while using ADG brass and may result in unsafe pressure levels.
