Tikka Threaded Bolt Handle

Tikka Threaded Bolt Handle in titanium construction.

Fits RIGHT hand actions ONLY.

.450 diameter where the shoulder starts to mate to bolt handle.

20-degree sweep.

Threaded 5/16-24.

Fits ALL Tikka T3, T3X, CTR and TAC A1.

• Due to variance in manufacturing between the t3 & t3x line there may be minor fitting needed for this bolt stem.
• *This bolt handle is not compatible with the Tikka T1X and the Tikka 695. 

Notes on Tikka factory tolerances

This part may not be a ‘drop-in’ fit for your individual rifle, some fitting may be required. Bear in mind that you are purchasing a handle which has been machined to be a much tighter fit than the mass-produced unit that your rifle came with. There exist variations between individual rifles of the slot dimensions in the bolt body where the handle slides into. The angles of this ‘dovetail’ will vary between individual rifles. Our Tikka T3 / T3x handles are machined in this critical dimension to tolerances of ± 0.025mm (± 0.001″) and we verify these dimensions for every single handle before they are packed using EDM-cut go and no-go gauges. Variations like this are common with mass-produced factory rifles, in the majority of cases our handle will slot firmly into the bolt body with minimal movement, however in some instances minor filing or stoning of one or both angles of our handle will be required to see it fit. If in doubt, take it to your gunsmith.

J&A Outdoors – Firearm Solutions – Shooting Products (jaoutdoors.com)

Choose | Tikka